Home :: Data Acquisition :: LabJack Accessories :: LJTick-Level Shifter

LJTick-Level Shifter

LJTick-Level Shifter

The LJTick-Divider (LJTD) is a signal-conditioning module designed to divide 2 single-ended channels of higher voltage analog signals down to 0-2.5 volt signals. They have ±10 volt inputs (BIP10V). The 4-pin design plugs into the standard AIN/AIN/GND/VS screw terminal block found on newer LabJacks such as the U3, U6, and UE9. The use of large resistors and a precision op-amp buffer provide an input impedance of 1 MΩ. By adding or replacing resistors, many other configurations are possible.

Terminals:

VINA/VINB: These screw terminals are for the 2 single-ended channels of input analog voltages. The input to either of these is ±10 volts, and the module produces 0 to 2.5 volts on the respective OUT pin.

GND: Same as LabJack ground. VINA/VINB must be referred to this ground.

VREF: A 2.5 volt reference voltage output. Internally this reference is used for level shifting, but very little current is used, leaving substantial current available to the user if a very accurate 2.5 volt reference is needed.

Documents:

Datasheet on the LabJack website

PS12DC Dimension:

Support:


SKU:  LAJ-036

1 available

1 available

Qty. Price
(AUD ex. GST)
1 to 4 $47.50
5 to 9 $42.75 (10% off)
10+ $40.38 (15% off)