Home :: Prototyping :: IMU Sensors

IMU Sensors


Sort by: Product SKU Price
ADXL335 Triple Axis Accelerometer Breakout Board
Analog Devices ADXL335 three axis accelerometer with analog voltage outputs on a breakout board. ±3 g range. 1.8 to 3.6 VDC powered. Read more…
$21.50 + GST
1 available
ADXL345 Triple Axis Accelerometer Breakout Board
ADXL345 triple axis accelerometer breakout board. The ADXL345 can be programmed for ±2 to ±16 g range and has tap/double tap and free-fall detection features. 2 to 3.6 VDC. SPI/I2C Interface. Read more…
$25.75 + GST
1 available
Axis Magnetometer Breakout - HMC5883L
This is a breakout board for Honeywell's HMC5883L, a 3-axis digital compass. Communication with the HMC5883L is simple and all done through an I2C interface. Read more…
$21.50 + GST
2 available
BMA180 Triple Axis Accelerometer
This is a breakout board for Bosch's BMA180 three-axis, ultra-high performance digital accelerometer. The BMA180 provides a digital 14-bit output signal via a 4-wire SPI or I2C interface. Read more…
$19.00 $9.50 + GST
save 50%
5 available
Essential Sensor Kit
Want to start playing with sensors, but don't know where to begin? This kit includes a variety of basic sensors for any beginner or experienced programmer.  Read more…
$59.00 + GST
3 available
ITG-3200 Triple-Axis Digital-Output Gyro Breakout
This is a breakout board for InvenSense's ITG-3200, a groundbreaking triple-axis, digital output gyroscope. The ITG-3200 features three 16-bit analog-to-digital converters (ADCs) for digitizing the gyro outputs, a user-selectable internal low-pass filter bandwidth, and a Fast-Mode I2C (400kHz) interface. Read more…
$22.00 $11.00 + GST
save 50%
1 available
LPS25H Pressure/Altitude Sensor Carrier With Voltage Regulator
This board is a compact (0.4″ × 0.8″) carrier for ST’s LPS25H digital barometer. It measures pressure from 260 mbar to 1260 mbar (26 kPa to 126 kPa) with absolute accuracy down to ±2 mbar (0.2 kPa) and typical RMS noise of 0.01 mbar (1 Pa) in high-resolution mode.The board has a 3.3 V linear regulator and integrated level shifters that allows it to work over an input voltage range of 2.5 V to 5.5 V, the sensor offers I²C and SPI interfaces. Read more…
$13.95 + GST
3 available
LSM303 Tilt Compensated Compass
The LSM303DLH is a triple axis accelerometer combined with a triple axis magnetic sensor. This breakout board uses the LSM303DLH to give a you the data you need to feed into a microcontroller and calculate tilt-compensated output. Read more…
$16.00 $9.95 + GST
save 38%
1 available
MMA8452Q Triple Axis Accelerometer Breakout Board
The MMA8452Q is a ±2/±4/±8 g range selectable three axis accelerometer with 12 bits of resolution. I2C interface. 1.95 to 3.6 VDC powered. Read more…
$14.50 + GST
3 available
SparkFun 9 Degrees of Freedom IMU Breakout - LSM9DS1
The LSM9DS1 is a versatile, motion-sensing system-in-a-chip. It houses a 3-axis accelerometer, 3-axis gyroscope, and 3-axis magnetometer – nine degrees of freedom (9DOF) in a single IC! Read more…
$39.95 + GST
2 available
3 axis Compass and Accelerometer Carrier with Voltage Regulator
3 axis Compass and Accelerometer Carrier with Voltage Regulator. Read more…
$19.55 + GST
3 available
9 Degrees of Freedom - Razor IMU - 16MHz
The 9DOF Razor IMU incorporates three sensors - a triple-axis gyro, a triple-axis accelerometer and a triple-axis magnetometer to give you nine degrees of inertial measurement. The outputs of all sensors are processed by an on-board ATmega328 and output over a serial interface. This enables the 9DOF Razor to be used as a very powerful control mechanism for UAVs, autonomous vehicles and image stabilization systems. Read more…
$109.00 + GST
2 available
9 Degrees of Freedom Sensor Stick
The 9DOF Sensor stick is a very small sensor board with 9 degrees of
freedom. It includes the ADXL345 accelerometer, the HMC5883L
magnetometer, and the ITG-3200 gyro. Read more…
$72.00 + GST
3 available