- Computer Products
- Data Acquisition
- Data Loggers
- Electrical Switches
- Electrical Terminals-Wiring
- Large Displays
- Modbus-Bacnet-MBus Products
- Motor Drivers & Controllers
- Motors & Accessories
- Panel Meters
- PLCs & HMIs
- Power Supplies
- Relays & Relay Cards
- 1 Wire
- Capacitive Proximity
- Float Switches
- Hall Effect
- Inductive Proximity
- Length & Distance
- Light & Colour
- Limit & Foot Switches
- Liquid Level
- Load Cells
- PhotoElectric Switches
- Pressure Transducers
- Smartphone Based
- Temperature RTD and T/C
- Temperature Other
- Temperature & Humidity
- Signal Conditioners
- Test Equipment
SKU: LAJ-031In stock (3 items available)
Plugs directly into the standard screw terminal block found on newer U3/U6/UE9. On board switch allows 5 various gain settings, one of them being custom.
SKU: LAJ-032Available for backorder
Allows 2 digital I/O lines on a U3, U6 and UE9 to each control a relay or other moderate load. Each has a switch to ground (i.e open-collector) that can hold off up to 50 V and can sink up to 200 mA.
SKU: LAJ-034In stock (6 items available)
A signal conditioning module designed to convert two 4 to 20 mA current loop signals into voltage signals that vary from 0.472 to 2.360 V.
SKU: LAJ-003In stock (3 items available)
Temperature sensor mounted in a plastic tube with a current limiting resistor. The probe is suitable for air, surface and non-corrosive liquids.
SKU: LAJ-012In stock (2 items available)
Plugs directly into the bottom of a LabJack U6 or UE9 to give screw terminal access to extra IO signals.
SKU: LAJ-014In stock (5 items available)
Provides convenient screw terminal access to 12 digital I/O available on a DB15 connector.
SKU: LAJ-002In stock (2 items available)
Screw terminal connections, with short-circuit and overvoltage protection, for the extra 16 digital I/O on the LabJack U12.
SKU: LAJ-006In stock (4 items available)
High-level linear voltage output and high accuracy. Operating temperature range from 0 to +150 °C.
SKU: LAJ-033In stock (3 items available)
8×8 grid of holes for prototyping custom signal-conditioning ticks.
SKU: LAJ-018In stock (6 items available)
Short, 37 pin cable suits the expansion plug on the LabJack U6, U6-Pro, UE9 and UE9-Pro.
SKU: LAJ-035In stock (4 items available)
LJTick-DAC is an analog output expansion module that provides a pair of 14-bit analog outputs with a range of ±10 V.
SKU: LAJ-030In stock (3 items available)
A signal conditioning module that divides 2 single-ended uni-polar channels of 0 to 10 V analog signals down to 0 to 2.5 V signals.