Power supply: 3.6V lithium battery (1/2 AA), built-in
- Temperature: -40 °C to 80 °C
- Relative Humidity (RH): 0 to 100 %
- Temperature: 0.1 °C
- Relative Humidity (RH): 0.1 %
Measurement interval: From 1 second to 18 hours
Estimated autonomy: Higher than 200 days with one weekly download and 5 minutes measuring interval. Battery life depends heavily on data retrieval frequency.
Logger PC data transfer time: According to the number of logs. 40 seconds for 16,000 logs.
PC interface: Ir/USB or Ir/Serial
Infrared communication range: 50 cm, 30° angle
Memory: 32K recordings in one channel
Operating temperature: –40 °C to 70 °C
- Electronic circuit case: IP65
- Sensors capsule: IP40
Dimension: 60 x 70 x 35 mm
The configuration of the LogBox is done by the included LogChart software. Data is transmitted to the LogBox through an Infrared wand connected to the PC's USB port. The Parameter Configuration window in LogChart lets you configure the following parameters:
- Logging session title
- Channel setup - name, type, limits, scaling
- start log options - immediately or timed
- log rate
- logging options - stop when full, set number of readings or roll-over
After the logging session is complete, data can then be downloaded again by LogChart and displayed in table and chart formats. Data files can then be saved as ASCII text files for importation into common Spreadsheets. It is also possible to monitor data in real-time.