Ocean Controls

Dual 10K, 5%, 1W resistors for general purpose use

Dual 120 Ohm, 5%, 1W resistors for RS-485 bus termination or general purpose use

Dual 1K Ohm, 5%, 1W resistors for adapting 12V systems to Leadshine stepper motor drives

Dual 2K2 Ohm, 5%, 1W resistors for adapting 24V systems to Leadshine stepper motor drives

Dual 4K7 Ohm, 5%, 1W resistors for general purpose use

DIN rail mounting. Isolated DC output up to 500mA. Short circuit and overload protection.

470 Ohm & 330 Ohm Resistive Divider, for stepping down a 24V DC supply to 10V. Useful as a feed voltage to a potentiometer for 0-10V control for VSD, etc.

4K7 and 10K, 5%, 1W resistors for voltage divider or general purpose applications

Trigger SMS alarms using up to 16 isolated digital inputs.

4 independent channels with switch-selectable NPN or PNP input and NPN or PNP output. Can be used as a NPN - PNP converter or as an isolator to eliminate noise and ground loops

4 independent channels with switch-selectable NPN or PNP input and NPN or PNP output. Can be used as a NPN - PNP converter or as an isolator to eliminate noise and ground loops. DIN-rail mount.

The KTA-366 is a 4-20mA loop powered current calibrator designed to make testing and measuring 4-20mA loops simple, it is suitable for testing 2 and 3 wire transducers; it has two operating modes, Simulate and Generate mode.

Regulated Plug Pack and Universal Test Lead Kit to be purchased separately.

Dual 500 Ohm, 0.1%, 1W resistors, suitable for converting 4 to 20 mA loops to 2 to 10V

Dual 250 Ohm, 0.1%, 1W resistors, suitable for converting 4 to 20 mA loops to 1 to 5V.

120 Ohm resistor and 0.1uF capacitor for back EMF suppression on AC loads

This shield allows you to connect 8 Thermocouples to your Arduino

Interfaces a Davis Instruments Weather Station to a BACnet MS/TP network

D15 High Density Female Terminal Card

D15 High Density Female Terminal Card with DIN Rail Mount

D15 High Density Male Terminal Card

D15 High Density Male Terminal Card with DIN Rail Mount